| Management number | 250625742 | Release Date | 2026/09/17 | List Price | US$37.08 | Model Number | 250625742 | ||
|---|---|---|---|---|---|---|---|---|---|
| Category | |||||||||
The AutoPot GeoPot System pairs gravity-fed, electricity-free AutoPot irrigation with BPA-free, lead-free GeoPot G Lite fabric pots in 3-gallon or 5-gallon sizes. Each pot sits in its own XL tray with an AQUAvalve5 that fills to 1" of water, shuts off, and only reopens after the plant has consumed the entire supply. No pumps, no timers, no power outlet required. Start with a 1-pot system and expand to 100 pots on a single reservoir using tee connectors and expansion modules.
When root tips hit the porous fabric wall, air dries them and triggers secondary branching. The result is a dense, fibrous root mass with more surface area for nutrient uptake instead of roots spiraling at the edge of a plastic pot.
The dual-float valve fills each tray to 1" depth, then closes. It reopens only after the plant uses the entire supply, creating a true wet/dry cycle without any programming or electricity.
The AQUAvalve5 has a 5mm inlet, 66% larger than the previous generation. Wider 3/8" fittings and pipework mean faster flow through the system and far fewer blockages over a full grow cycle.
GeoPot G Lite fabric is certified against off-gassing and leaching. Seams use bonded polyester thread, and the rigid base helps keep plants upright in the XL tray.
Start with a 1-pot or 2-pot system. When you need more, add GeoPot expansion modules. Each module includes a tray, pot, valve, PotSock, pipe, and tee connector.
After harvest, let pots dry and brush off residue. For deeper cleaning, tub-wash in peroxide. Do not tumble dry. Most growers reuse the same GeoPots for years.
Position your reservoir at least 6" above the highest AQUAvalve5. Gravity is the only force moving water, so height matters. Install the tank filter and connect your 3/8" pipe run to the first tray.
Place a PotSock Round on the base of each GeoPot before filling. Use a 50/50 blend of growing media and aeration material (perlite, pumice, or clay pebbles). Transplant into the fabric pot and top-water by hand for the first 1 to 2 weeks to establish roots.
Once roots are established, open the inline tap. Each AQUAvalve5 fills its tray to 1", shuts off, and waits for the plant to drink before refilling. From this point, do not top-water.
Check the reservoir every few days and top off when it reaches one-third full. If it runs completely empty, air enters the lines and the AQUAvalve5 can lose its vacuum seal. Top off early, top off often.
Questions? We're easy to reach.
Happy Hydro has been serving growers since 2006. Call or email us before you order, after you order, or any time something comes up. When you're happy, we're happy.
If you notice any omissions or errors in the product information on this page, please use the correction request form below.
Correction Request Form