Green Pad Jr. CO2 Generator Pads

Green Pad Jr. CO2 Generator Pads - 10 Pads

Green Pad Jr. CO2 Generator Pads are an innovative and very easy way to supplement your indoor grow environments with Carbon Dioxide. CO2 will give you higher yields and healthier plants for your indoor hydroponic and soil grows. Especially great for jump starting clones!

Green Pad Jr CO2 Generator Pads absorb the humidity in your propagation dome, to power its natural chemical reaction, releasing a measured amount of carbon dioxide. CO2 accelerates the natural rooting process for cuttings and seedlings so they can establish healthy roots and more nodes by feeding the leaves. This helps the cuttings and seedlings to root faster so you can move to VEG sooner and grow healthier larger fruits, herbs and vegetables.

The Green Pad Jr. gives you higher strike rates, less leaf yellowing, faster rooting by 2-3 days or more, allowing you to move healthy rooted cuttings and seedlings to veg faster.

The Green Pad Jr. is placed in the humidity dome and replaced every other day until you are fully rooted or when you remove the dome. It's that easy!

Very inexpensive to have on-hand, and if you don't use them immediately, they'll be good to go when you need them for up to a year. Make sure to keep the remaining The Green Pad Jr.'s dry in the original packaging, and they will last over a year.

EASY TO USE: Simply place 1 Green Pad Jr. in your dome and replace with a new one every other day until your rooted or you remove the dome. Reseal the package and use remaining pads when needed. The unused pads will be ready to use and will NOT activate until you need them.

GREAT FOR SEEDLINGS AND CLONES: Commercial carbon dioxide supplement made specifically for seedlings and clones

HUMIDITY ACTIVATED: Absorbs the humidity in your propagation dome powering natural chemical reaction and releasing a measured amount of carbon dioxide

PRODUCES HEALTHY PLANTS: Provides higher strike rates, less leaf yellowing, and faster rooting by 2 to 3 days or more

10 PADS INCLUDED: Includes 10 pads for use on multiple clones and seedlings

CO2 and Your Clones

There are a few different ways a grower can increase the CO2 level in the cloning area. However, too much of a good thing can be bad. When using a CO2 system designed for a large area, a grower should be cautious to avoid the CO2 levels getting too concentrated.

For clones, CO2 levels between 1,000-1,300 ppm should be the maximum. Levels above this can be counterproductive as the available oxygen gets displaced by CO2. The roots (or potential roots) need some oxygen to develop and thrive. Growers who choose to use CO2 burners or compressed tanks with injector systems need to have a CO2 monitor/controller so the CO2 levels can be kept in check. Perhaps the best solutions for administering CO2 to clones are the CO2 pads specifically designed for cloning chambers.

These pads can be placed directly into a standard propagation tray and dome and are activated by the humidity within (or when the clones are misted with water). The CO2 pads are made from natural chemicals which, when exposed to humidity, begin to release CO2. Since the pads are made specifically for propagation trays and cloning,