FinalPart® is a complete late-flowering nutrient/stimulant requiring no additional boosters. It increases flowering and production of active principles and eliminates nutrient excess.

• It sends the plant a strong signal that it is coming to the end of its life; this prompts the plant to accelerate the ripening process.
• It forces the plant to strengthen its defences and thus increase essential oil and active principle production.
• It delivers all the mineral salts the plants need in a form that is easy to assimilate: in case of a previous accumulation of nitrate or microelements, this helps metabolize residues, which improves taste. 

As a “forcing solution“, FinalPart® can be used in any circumstance where you need to control or enhance ripening, and at the end of every flowering/fruiting cycle of annual flowers and fruits to maximise yield and flavour intensity.

Outdoors, FinalPart® enables you to quickly harvest a  crop before it is spoiled by cold and damp weather. Indoors, it helps you harmonise the end of the grow cycle by speeding up the ripening of the slowest plants or varieties. And in case of a severe infestation of fungi or insects, it can allow you to accelerate the natural cycle and recover something out of a crop that would otherwise be completely lost.

• In hydroponics: Replace old nutrient solution with pH adjusted water add up to 5ml/L of FinalPart® to match or slightly exceed your previous EC (up to 2.6) and mix well. Run for 10 days, or as needed, then use FlashClean® to finish or harvest your crop directly.  
• In soil: Apply in pH adjusted water at up to 4ml/L to match or slightly exceed your previous EC (up to 2.0). Apply until leaf yellowing occurs and / or ripening is satisfactory. This can take from 10 to 20 days. Then use FlashClean® to finish or harvest your crop directly.  
• Expert growers can use FinalPart® to manipulate water stress to maximise active principal concentration, and minimise splitting in soft fruit culture: target EC 2.6 ms in hydro and target EC 2.0 ms in soil. 

As an indication, here are the recommended doses and durations, to be adapted according to the substrates and their retention and accumulation rate.

• LOW RATE SUBSTRATE (clay pebbles, hydroponics, bare roots): Replace old nutrients solution, then use FinalPart for about 10 days, dosing at 5ml of FinalPart® per litre of water. 
• MEDIUM RATE SUBSTRATE (coconut, fibre, perlite...): use FinalPart® for about 12-13 days, dosing at 5ml of FinalPart per litre of water
• HIGH RATE SUBSTRATE (potted soil, open ground...): use FinalPart® for about 15 days, dosing at 4 ml of FinalPart per litre of water. 

ALWAYS use FinalPart® alone - do not combine any other nutrients, fertilisers or fortifiers while using FinalPart® as everything the plant needs to complete its life and maturation is already in the formula.

However, you can improve your harvest by using the other products in the T.A. range BEFORE and AFTER this phase:

• TriPart